This shows you the differences between two versions of the page.
Next revision | Previous revisionNext revisionBoth sides next revision | ||
advanced-pbr [2022/01/05 12:45] – created rs232 | advanced-pbr [2022/01/31 23:45] – hogwild | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | tbd. | + | ===== MultiWan Routing ===== |
+ | |||
+ | While similar to the Routing menu, the MultiWAN Routing menu allows you to direct outbound traffic in multiwan scenarios. On this menu, you can define advanced parameters to make a connection bind to a specific WAN. Where outbound traffic is directed will implicitly affect the corresponding (inbound) return traffic. A packet going to WAN0 should return only via the same interface. | ||
+ | |||
+ | \\ | ||
+ | |||
+ | {{: | ||
+ | |||
+ | **On**: When enabled, makes active the routing rule on that line of the table. | ||
+ | |||
+ | **Protocol**: | ||
+ | |||
+ | * All Protocols * (Default). | ||
+ | * TCP+UDP | ||
+ | * TCP | ||
+ | * UDP | ||
+ | * ICMP | ||
+ | |||
+ | This dropdown lets you choose the transport protocols that should be matched by the rule. Note that there are hundreds of layer 4 protocols. This menu and setting refer to only the most common ones. | ||
+ | |||
+ | **Source Address**: | ||
+ | |||
+ | * All | ||
+ | * IP | ||
+ | * MAC | ||
+ | |||
+ | Filters in the defined source of traffic. All filters in all LAN devices. The IP setting allows you to define a specific IP address or set of addresses using a netmask syntax (e.g. 192.168.1.0/ | ||
+ | |||
+ | **Destination Address**: | ||
+ | |||
+ | * All | ||
+ | * IP | ||
+ | * Domain | ||
+ | |||
+ | Similar to the source IP, the destination address makes the rule more restrictive based on/or destination address. This can be defined as ALL (as in Internet), IP address or set of addresses, defined in a netmask format or even a destination domain. | ||
+ | |||
+ | **Selected WAN**: WANx - Specfies the logical interface where the defined outbound traffic should be directed. | ||
+ | |||
+ | **Description**: | ||
+ | |||
+ | Please note that the rules defined will take precedence over any WAN's weight-related setting.\\ | ||
+ |