This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
advanced-pbr [2022/01/31 23:45] – hogwild | advanced-pbr [2023/06/05 03:19] – [Rules] -formatting hogwild | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== MultiWan Routing ===== | ===== MultiWan Routing ===== | ||
- | While similar to the Routing menu, the MultiWAN Routing menu allows you to direct outbound traffic in multiwan scenarios. On this menu, you can define advanced parameters to make a connection bind to a specific WAN. Where outbound traffic is directed will implicitly affect the corresponding (inbound) return traffic. A packet going to WAN0 should return only via the same interface. | + | While somewhat |
- | \\ | + | This menu lets you define advanced parameters to make a connection bind to a specific WAN. Where outbound traffic is directed will implicitly affect the corresponding (inbound) return traffic. A packet going to WAN0 should return only via the same interface. |
+ | |||
+ | |||
+ | ===== Rules ===== | ||
{{: | {{: | ||
- | **On**: When enabled, makes active | + | **On**: When checked, this enables |
- | **Protocol**: | + | **Protocol**: |
* All Protocols * (Default). | * All Protocols * (Default). | ||
Line 17: | Line 20: | ||
* ICMP | * ICMP | ||
- | This dropdown lets you choose the transport protocols that should be matched by the rule. Note that there are hundreds of layer 4 protocols. This menu and setting refer to only the most common ones. | + | **Source Address**: |
- | + | ||
- | **Source Address**: | + | |
* All | * All | ||
Line 25: | Line 26: | ||
* MAC | * MAC | ||
- | Filters in the defined | + | **Destination Address**: |
- | + | ||
- | **Destination Address**: | + | |
* All | * All | ||
Line 33: | Line 32: | ||
* Domain | * Domain | ||
- | Similar to the source IP, the destination address makes the rule more restrictive based on/or destination address. This can be defined as ALL (as in Internet), IP address or set of addresses, defined in a netmask format or even a destination domain. | + | **Select WAN**: |
- | **Selected WAN**: WANx - Specfies the logical interface where the defined outbound traffic should be directed. | + | **Description**: In this field, you can enter any notes you wish to make management easier.\\ |
- | **Description**: | + | Rules defined will take precedence over any WAN's weight-related setting. |
+ | |||
+ | \\ | ||
- | Please note that the rules defined will take precedence over any WAN's weight-related setting.\\ | + | |