FreshTomato Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
===== MultiWAN Routing =====

While somewhat similar to the Routing menu, the MultiWAN Routing menu allows you to direct outbound traffic in multiwan scenarios.

This menu lets you define advanced parameters to make a connection bind to a specific WAN. Where outbound traffic is directed will implicitly affect the corresponding (inbound) return traffic. A packet going to WAN0 should return only via the same interface.


===== Rules =====

{{:pasted:20220126-181958.png}}\\  \\

**On**: When checked, this enables the routing rule on that line of the table.

**Protocol**:  This lets you choose the transport protocols that will be matched by the rule. There are hundreds of layer 4 protocols. This menu and setting refer to only the most common ones.

  * All Protocols * (Default).
  * TCP+UDP
  * TCP
  * UDP
  * ICMP

**Source Address**:  Filters in the defined source of traffic. All filters in all LAN devices. The IP setting allows you to define a specific IP address or set of addresses using a netmask syntax (e.g. 192.168.1.0/24), where MAC binds the rule to a defined MAC Address only.

  * All
  * IP
  * MAC

**Destination Address**:  Similar to the source IP, the destination address makes the rule more restrictive based on/or destination address. This can be defined as ALL (as in Internet), IP address or set of addresses, defined in a netmask format or even a destination domain.

  * All
  * IP
  * Domain

**Select WAN**:  (WANx) - Here, you choose the logical interface where the defined outbound traffic will be directed.

**Description**: In this field, you can enter any notes you wish to make management easier.\\

Rules defined will take precedence over any WAN's weight-related setting.

 \\

 \\ \\
FreshTomato Wiki

User Tools

Site Tools

Page Tools
