This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
advanced-routing [2022/01/21 03:14] – clarity, formatting hogwild | advanced-routing [2023/06/24 19:43] – -add point to intro about displaying current table hogwild | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== Routing ===== | ===== Routing ===== | ||
- | The Routing page allows you to define the output interface for specific destinations (IP and Subnets). | + | The Routing page allows you to view the current routing table. It also allows you to define the output interface for specific |
\\ | \\ | ||
- | {{: | + | {{: |
- | \\\\ The Current Routing Table displays the output from the '' | + | \\ |
+ | |||
+ | The Current Routing Table displays the output from the '' | ||
A default table entry should be present which indicates traffic going towards the Internet.\\ | A default table entry should be present which indicates traffic going towards the Internet.\\ | ||
- | {{: | + | \\ |
- | The Static Routing Table is manually created. Here, you can would define static routes (with their netmask and gateway) towards specific destinations. While this is not normally needed, it might be useful for advanced setups such as like intranets, VPN, and so on.\\ \\ | + | {{: |
- | {{: | + | \\ The Static Routing Table is manually created. Here, you can define static routes (with their netmask/ |
- | If the WAN interface is assigned IP addressing via DHCP, this options | + | \\ |
+ | |||
+ | {{: | ||
+ | |||
+ | \\ | ||
+ | |||
+ | If the WAN interface is assigned IP addressing via DHCP, this options | ||
+ | |||
+ | \\ NOTE: On older FreshTomato versions, there was an obsolete setting in this menu that suggested FreshTomato can operate in Gateway mode or Router mode. Ignore this, and leave it set to " | ||
+ | |||
+ | \\ | ||
+ | |||
+ | [[https:// | ||
+ | |||
+ | \\ | ||