Site Tools


advanced-routing

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
advanced-routing [2022/01/21 03:16] hogwildadvanced-routing [2023/06/24 19:46] (current) hogwild
Line 1: Line 1:
 ===== Routing ===== ===== Routing =====
  
-The Routing page allows you to define the output interface for specific destinations (IP and Subnets).+The Routing page allows you to view the current routing table. It also allows you to define the output interface for specific routing destinations (both IP addresses and Subnets).
  
  \\  \\
Line 11: Line 11:
 The Current Routing Table displays the output from the ''route'' system command. The Current Routing Table displays the output from the ''route'' system command.
  
-A default table entry should be present which indicates traffic going towards the Internet.\\  \\+A default table entry should be present that indicates traffic going towards the Internet.\\  \\
  
  \\  \\
Line 17: Line 17:
 {{:pasted:20220110-191557.png}} {{:pasted:20220110-191557.png}}
  
- \\ The Static Routing Table is manually created. Here, you can define static routes (with their netmask/gateway) towards specific destinations. While this is not normally needed, it might be useful for advanced setups such intranets, VPNs, and so on.\\  \\+ \\ The Static Routing Table is manually created. Here, you can define static routes (with their netmask/gateway) towards specific destinations. While not commonly needed on simple networksthis may be useful for advanced setups such as intranets, VPNs, and others.\\  \\
  
  \\  \\
Line 25: Line 25:
  \\  \\
  
-If the WAN interface is assigned IP addressing via DHCP, this options specfies whether or not to accept routing information from the DHCP server. Such routing information is usually sent via DHCP option 33 or 121.+If the WAN interface is assigned an IP address via DHCP, this option specifies whether to accept routing information from the DHCP server. Such information is usually sent via DHCP option 33 or 121. 
 + 
 + \\ On older FreshTomato versions, there was an obsolete setting in this menu that suggested FreshTomato can operate in Gateway mode or Router mode. Ignore this, and leave it set to "Gateway", regardless of your configuration. 
 + 
 + \\ 
 + 
 +[[https://wiki.freshtomato.org/lib/exe/detail.php?id=basic&media=a16bb07aecd3c3d8967615c6fef64760.png|{{:a16bb07aecd3c3d8967615c6fef64760.png}}]] 
 + 
 + \\ 
 + 
 + \\ \\
  
  
advanced-routing.1642735017.txt.gz · Last modified: 2022/01/21 03:16 by hogwild