This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
basic-network [2023/09/12 17:40] – [Wireless (5 GHz / interface eth2)] hogwild | basic-network [2024/05/07 03:35] – [MultiWAN] -removed "regularly" hogwild | ||
---|---|---|---|
Line 25: | Line 25: | ||
Choosing a setting other than Disabled will make " | Choosing a setting other than Disabled will make " | ||
- | * Target 1 -** **Here, enter the address of the first host to ping regularly | + | * Target 1 -** **Here, enter the address of the first host to ping (Default: Google.com) |
- | * Target 2 - Here, enter the address of the second host to ping regularly | + | * Target 2 - Here, enter the address of the second host to ping (Default: Microsoft.com)\\ |
Line 92: | Line 92: | ||
\\ | \\ | ||
+ | |||
+ | \\ | ||
+ | |||
+ | **Load Balance Weight: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | When configuring a router in a MultiWAN configuration, | ||
+ | |||
+ | For example: | ||
+ | |||
+ | Let's assume we have 2 WANs, as follows: | ||
+ | |||
+ | WAN0=" | ||
+ | |||
+ | WAN1=" | ||
+ | |||
+ | At some point, WAN1 fails. As soon as this failure is noticed, WAN0 will activate (assigned with weight 1) and begin routing packets. Later, WAN1 recovers its connectivity. As soon as FreshTomato recognizes this, (within seconds or minutes), WAN0 will be set back to idle status while traffic is rerouted through the revived WAN1. This process of recovering back to the originally active interface is called // | ||
\\ | \\ | ||
Line 387: | Line 405: | ||
* This is usually only for advanced users. \\ \\ | * This is usually only for advanced users. \\ \\ | ||
- | **Shared Key: | + | **Shared Key: |
+ | |||
+ | **Group Key Renewal: | ||
+ | |||
+ | Starting with release 2023.5, you can adjust the key rotation interval within the following limits:\\ From 1 sec to 2592000 sec [for all ARM routers and MIPS RT-N / MIPS-RT-AC] \\ 0 = disabled | ||
- | **Group Key Renewal: | + | In releases up to 2023.4, you can set this within |
Line 502: | Line 524: | ||
**Group Key Renewal: | **Group Key Renewal: | ||
- | (Default: 3600 seconds). | + | (Default: 3600 seconds). |