Differences

This shows you the differences between two versions of the page.

--- enable_disable_ethernet_port [2020/09/29 14:10] – rs232
+++ enable_disable_ethernet_port [2023/05/24 01:36] – hogwild
@@ Line 1: / Line 1: @@
-You can enable/disable specific LAN ports via command line as follow.
+====== Enable/disable Ethernet port(s) ======
-To identify the port use the command
+You can enable/disable specific LAN ports via command line as follows:
-<code>
+ \\
-robocfg show port
+To identify the port, use the command:
+ \\
+<code ->
+robocfg show port
 </code>
-Once the physical port is identified, to disable (replace x with the port number):
+ \\  \\ \\  Once the physical port is identified, to disable it (replace x with relevant port number on your router):
-<code>
+ \\
- robocfg port x state disabled
+<code ->
+robocfg port x state disabled
 </code>
-To enable instead:
+  \\ \\  To enable it:
-<code>
+ \\
-robocfg port x state enabled
+<code ->
+robocfg port x state enabled
 </code>
-NOTE: you might be trying to fix an issue with an ethernet connected device. If the issue is the negotiated speed you can also try a dfferent approach like forcing 10MB Full Duplex before setting it back to Auto-negotiation again e.g.
+ \\ \\ You might be trying to resolve an issue with an Ethernet-connected device. If the negotiated speed is causing the problem, you can test forcing 10MB/s Full Duplex connections before setting it back to Auto-negotiation. For example:
-<code>
+ \\
-''robocfg port 2 media 10FD''
-''robocfg port 2 media auto''
+<code ->
+robocfg port 2 media 10FD
+robocfg port 2 media auto
 </code>
+ \\
+ \\
+ \\

FreshTomato Wiki

User Tools

Site Tools

Differences

Page Tools