This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
enable_disable_ethernet_port [2021/08/24 15:01] – rs232 | enable_disable_ethernet_port [2023/05/24 01:36] – hogwild | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Enable/ | ====== Enable/ | ||
- | | + | You can enable/ |
+ | |||
+ | \\ | ||
To identify the port, use the command: | To identify the port, use the command: | ||
+ | |||
+ | \\ | ||
<code -> | <code -> | ||
Line 9: | Line 13: | ||
</ | </ | ||
- | | + | \\ \\ \\ Once the physical port is identified, to disable it (replace x with relevant port number on your router): |
+ | |||
+ | \\ | ||
<code -> | <code -> | ||
robocfg port x state disabled | robocfg port x state disabled | ||
- | |||
</ | </ | ||
- | \\ To enable it: | + | \\ \\ To enable it: |
+ | |||
+ | \\ | ||
<code -> | <code -> | ||
Line 22: | Line 29: | ||
</ | </ | ||
- | | + | |
+ | |||
+ | \\ | ||
<code -> | <code -> | ||
Line 28: | Line 37: | ||
robocfg port 2 media auto | robocfg port 2 media auto | ||
</ | </ | ||
+ | |||
+ | \\ | ||
+ | |||
+ | \\ | ||
+ | |||
+ | \\ | ||