Differences

This shows you the differences between two versions of the page.

--- enable_disable_ethernet_port [2020/09/29 12:11] – rs232
+++ enable_disable_ethernet_port [2023/05/24 01:38] (current) – hogwild
@@ Line 1: / Line 1: @@
-You can enable/disable specific LAN ports via command line as follow.
+====== Enable/disable Ethernet port(s) ======
-To identify the port use the command
+You can enable/disable specific LAN ports via command line as follows:
-<code>
+ \\
+To identify the port, use the command:
+ \\
+<code ->
 robocfg show port
+</code>
+ \\  \\ \\  Once the physical port is identified, to disable it (replace x with relevant port number on your router):
+ \\
+<code ->
+robocfg port x state disabled
+</code>
+ \\
+ \\  \\ To enable it:
+ \\
+<code ->
+robocfg port x state enabled
+</code>
+ \\ \\ You might be trying to resolve an issue with an Ethernet-connected device. If the negotiated speed is causing the problem, you can test forcing 10MB/s Full Duplex connections before setting it back to Auto-negotiation. For example:
+ \\
+<code ->
+robocfg port 2 media 10FD
+robocfg port 2 media auto
 </code>
-Once the physical port is identified, to disable:
+ \\
-<bbCodeCode> ''robocfg port x state disabled'' </bbCodeCode> To enable instead:
+ \\
-<bbCodeCode> ''robocfg port x state enabled'' </bbCodeCode> where x is the port number involved
+ \\

FreshTomato Wiki