This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
entware_installation_usage [2021/09/21 10:07] – old revision restored (2021/09/19 21:47) djk44883 | entware_installation_usage [2023/05/08 05:31] – -clarity, grammar, spelling, formatting hogwild | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Entware Installation and Usage ====== | ====== Entware Installation and Usage ====== | ||
- | \\ [[https:// | + | \\ [[https:// |
- | **NOTE**: | + | You can find current, in-depth instructions for installing Entware |
- | ---- | + | \\ This example assumes you have a USB flash drive mounted at: /mnt/sda1. If you need more details about configuring USB storage, please see the [[: |
- | This example assumes you have a USB flash drive mounted under /mnt/sda1. If you need more details about configuring USB storage before reading this, see the [[: | + | \\ |
First, create the opt folder and mount it: | First, create the opt folder and mount it: | ||
+ | |||
+ | \\ | ||
<code -> | <code -> | ||
Line 16: | Line 18: | ||
</ | </ | ||
- | | + | \\ \\ Then, you can run the installation command: |
<code -> | <code -> | ||
Line 22: | Line 24: | ||
</ | </ | ||
- | | + | \\ \\ Finally, you can install the packages you want, for example: |
<code -> | <code -> | ||
Line 29: | Line 31: | ||
opkg install htop | opkg install htop | ||
</ | </ | ||
+ | |||
+ | \\ | ||
+ | |||
+ | \\ | ||