Site Tools


entware_installation_usage

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
entware_installation_usage [2020/06/08 10:29] rs232entware_installation_usage [2023/06/27 23:44] (current) – -update broken USB Support link hogwild
Line 1: Line 1:
-====== Entware ======+====== Entware Installation and Usage ======
  
-Assuming your USB drive is mounted under sda1:+\\ [[https://entware.net/about.html|Entware]] is a software repository for network attached storage, routers and other embedded devices. [[http://bin.entware.net/armv7sf-k3.2/Packages.html|2500+ packages]] are available for different platforms. Entware packages are full versions of programs/commands found in common Linux distributions. You can expand upon the BusyBox versions of commands included with FreshTomato and install packages not already installed. This allows you to "//push the limits//" of your router.
  
-first of all create the opt folder and mount it:+For more details on how to use Entware, see[[https://github.com/Entware/Entware/wiki#using-repo|The Entware Wiki]]
  
-**mkdir /mnt/sda1/opt**+There you can also find current, in-depth instructions for installing Entware in FreshTomato: [[https://github.com/Entware/Entware/wiki/Install-on-TomatoUSB-and-FreshTomato#entware-on-freshtomato-and-other-tomatousb-forks|Entware on FreshTomato (and other TomatoUSB forks)]]
  
-**mount -o bind /mnt/sda1/opt /opt**+ \\ This example assumes you have a USB flash drive mounted at: /mnt/sda1. If you need more details about configuring USB storage, please see the [[nas-usb|USB Support]] menu.
  
-To make the mount permanent\\ + \\
-ARM:\\ +
-wget -O - [[http://pkg.entware.net/binaries/armv7/installer/entware_install.sh|http://pkg.entware.net/binaries/armv7/installer/entware_install.sh]] | sh\\ +
-MIPS:\\ +
-wget -O - [[http://pkg.entware.net/binaries/mipsel/installer/installer.sh|http://pkg.entware.net/binaries/mipsel/installer/installer.sh]] | sh+
  
-At this point you can inatll packages e.g.+First, create the opt folder and mount it:
  
-**opkg install htop**+ \\ 
 + 
 +<code -> 
 +mkdir /mnt/sda1/opt 
 +mount -o bind /mnt/sda1/opt /opt 
 +</code> 
 + 
 + \\   \\  Then, you can run the installation command:  \\  \\ 
 + 
 +<code -> 
 +/usr/sbin/entware-install.sh 
 +</code> 
 + 
 + \\   \\ Finally, you can install the packages you want, for example:  \\  \\ 
 + 
 +<code -> 
 +opkg update 
 +opkg upgrade 
 +opkg install htop 
 +</code> 
 + 
 + \\ 
 + 
 + \\
  
  
entware_installation_usage.1591608589.txt.gz · Last modified: 2020/06/08 10:29 by rs232