Site Tools


faq

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
faq [2022/08/07 08:46] rs232faq [2023/04/30 16:34] – [Day 0] -clarity, condense, grammar hogwild
Line 9: Line 9:
  
   * You are on the right site.   * You are on the right site.
-  * Verify if your device is supported by your router via the [[hardware_compatibility|hardware compatibility]] page. Pay attention to the HW revision column and the notes. +  * Verify whether your device is supported by your router via the [[hardware_compatibility|hardware compatibility]] page. Pay attention to the HW revision column and the notes. 
-  * Overall the installation is relatively safe and, based on the HW model, there are few recovery procedures you can follow in the unlikely event something doesn't go to planThat said you are fully responsible for your device and the decision to upgrade to FreshTomato. +  * Overall the installation is relatively safe and, based on the HW model, there are few recovery procedures you can follow in the unlikely event things don't go to as plannedHowever, please know that you are fully responsible for your device and the decision to upgrade to FreshTomato. 
-  * You need to have an ethernet connection between your end device (laptop?and a LAN port of the router. +  * You need to have an Ethernet connection between your client device and a LAN port on the router. 
-  * You must read and follow the [[firmware_basics_procedures|Installing FreshTomato]] this will guide you through all the steps needed.+  * You must read and follow the [[firmware_basics_procedures|Installing FreshTomato]] section. This will guide you through all the steps needed.
  
  
Line 29: Line 29:
  \\  \\
  
-  * Default IPv4 address: 192.168.1.1 +  * Default IPv4 address: **192.168.1.1** 
-  * Netmask: 255.255.255.0+  * Netmask: **255.255.255.0**
  
  \\  \\
Line 38: Line 38:
 \\ \\
  
-  * Username: root +  * Username: **root** 
-  * Password: admin+  * Password: **admin**
  
 ===== How Do I Choose a Build? (build naming scheme) ===== ===== How Do I Choose a Build? (build naming scheme) =====
faq.txt · Last modified: 2024/04/28 17:28 by hogwild