User Tools
usb_formatting_with_swap_partition
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| usb_formatting_with_swap_partition [2021/08/16 22:45] – [Manual method:] hogwild | usb_formatting_with_swap_partition [2021/09/13 16:51] – [USB formatting with swap partition] hogwild | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| This example assumes you are using either an ARM or MIPS build with USB support. It is also assumes that you have already have USB support enabled. If you're not sure how to enable USB support, check the [[: | This example assumes you are using either an ARM or MIPS build with USB support. It is also assumes that you have already have USB support enabled. If you're not sure how to enable USB support, check the [[: | ||
| - | For this example we used a 16GB USB flash drive which is seen in the system as device **sda**. | + | For this example, we used a 16GB USB flash drive which is seen in the system as device **sda**. |
| + | |||
| ===== Automatic method ===== | ===== Automatic method ===== | ||
usb_formatting_with_swap_partition.txt · Last modified: 2024/03/27 15:32 by hogwild
Page Tools
