This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
usb_formatting_with_swap_partition [2024/03/27 15:22] – [Activating Swap Partition (Post Mount Command)] -formatting hogwild | usb_formatting_with_swap_partition [2024/03/27 15:32] (current) – [Deactivating the Swap Partition (Pre-unmount command)] -condense hogwild | ||
---|---|---|---|
Line 94: | Line 94: | ||
</ | </ | ||
- | \\ \\ | + | |
<code -> | <code -> | ||
Line 106: | Line 106: | ||
\\ | \\ | ||
+ | |||
===== Configuring Post-mount and Pre-unmount Commands ===== | ===== Configuring Post-mount and Pre-unmount Commands ===== | ||
Line 111: | Line 112: | ||
For best practice, the swap partition should be activated as swap once the USB drive/flash is mounted. Additionally, | For best practice, the swap partition should be activated as swap once the USB drive/flash is mounted. Additionally, | ||
+ | |||
+ | \\ | ||
==== Activating Swap Partition (Post Mount Command) ==== | ==== Activating Swap Partition (Post Mount Command) ==== | ||
Line 129: | Line 132: | ||
You may have additional commands within the field. | You may have additional commands within the field. | ||
)) | )) | ||
+ | |||
+ | \\ | ||
==== Deactivating the Swap Partition (Pre-unmount command) ==== | ==== Deactivating the Swap Partition (Pre-unmount command) ==== | ||
- | To configure the router to automatically deactivate the swap partition (in this case, **/// | + | To configure the router to automatically deactivate the swap partition (in this case, **/// |
+ | |||
+ | \\ | ||
<code -> | <code -> | ||
Line 139: | Line 146: | ||
</ | </ | ||
- | The field should appear | + | \\ |
+ | |||
+ | The field should appear | ||
{{: | {{: | ||
Line 145: | Line 154: | ||
)) | )) | ||
- | As usual, in both cases, the save button at the bottom | + | In both cases, |
===== Final setup ===== | ===== Final setup ===== |