Differences

This shows you the differences between two versions of the page.

--- virtual_wireless [2021/09/27 00:18] – Formatted table definitions hogwild
+++ virtual_wireless [2021/09/27 00:18] – [Notes] hogwild
@@ Line 8: / Line 8: @@
-  - When creating/defining a new wireless VIF (Virtual interface), its MAC address will be shown (incorrectly) as '00:00:00:00:00:00', as it is is unknown at that moment. It will display correctly as soon as the the network is restarted and this menu is reloaded.
+  - When creating/defining a new wireless VIF (Virtual interface), its MAC address will be shown (incorrectly) as '00:00:00:00:00:00', as it is unknown at that moment. It will display correctly as soon as the the network is restarted and this menu is reloaded.
   - When saving changes, the MAC addresses of all defined non-primary wireless VIFs could sometimes be (already) set but might be recreated by the wl driver (Broadcom's proprietary wireless LAN driver). Thus, previously defined/saved settings might need to be updated/changed accordingly in the Advanced/MAC Address menu after saving settings and rebooting your router.
   - The Tomato web interface allows configuration of a maximum of 4 VIFs for each physical wireless interface available - up to 3 extra VIFs can be defined in addition to the primary VIF (on devices with multiple VIF capabilities).
   - Configuration settings for the primary VIF of any physical wireless interfaces shouldn't be adjusted in this menu. Use the Basic/Network page for that instead.

FreshTomato Wiki