Differences

This shows you the differences between two versions of the page.

--- virtual_wireless [2021/09/27 00:03] – spelling, clarity, made Notes a subheading hogwild
+++ virtual_wireless [2023/05/26 06:33] (current) – [Notes] -delete all content-it's very outdated hogwild
@@ Line 1: / Line 1: @@
-    Interface - Wireless VIF name.
+    **Interface** - The wireless VIF (Virtual Interface) name \\
-    Enabled - If this VIF should be active and brought online.
+    **Enabled** - If this VIF should be active and brought online \\
-    SSID - Wireless Service Set Identifier.
+    **SSID** - The wireless Service Set Identifier \\
-    Mode - Interface mode: Access Point, WDS, Wireless Client, etc...
+    **Mode** - Allows selection of Interface mode: Access Point, WDS, Wireless Client, etcetera \\
-    Bridge - Which LAN bridge this VIF should be assigned.
+    **Bridge** - Allows you to select which LAN bridge this VIF should be assigned \\
-===== Notes =====
-When creating/defining a new wireless Virtual interface (VIF), its MAC address will be shown (incorrectly) as '00:00:00:00:00:00', as it's unknown at that moment (until the network is restarted and this page is reloaded.
-When saving changes, the MAC addresses of all defined non-primary wireless VIFs could sometimes be (already) set but might be recreated by the WL driver (so that previously defined/saved settings might need to be updated/changed accordingly on Advanced/MAC Address after saving settings and rebooting your router).
-The Tomato web interface allows configuration of a maximum of 4 VIFs for each physical wireless interface available - up to 3 extra VIFs can be defined in addition to the primary VIF (on devices with multiple VIF capabilities).
-Configuration settings for the primary VIF of any physical wireless interfaces shouldn't be adjusted here. Use the Basic/Network page instead.

FreshTomato Wiki

User Tools

Site Tools

Differences

Page Tools