User Tools
wireless_ethernet_bridge
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| wireless_ethernet_bridge [2023/06/06 20:31] – [Steps] -use lettered level2 bullets hogwild | wireless_ethernet_bridge [2023/06/18 22:28] (current) – [Steps] -formatting hogwild | ||
|---|---|---|---|
| Line 30: | Line 30: | ||
| - Configure your PC with a static IP address in the same subnet as the secondary router (e.g., 192.168.1.33).\\ | - Configure your PC with a static IP address in the same subnet as the secondary router (e.g., 192.168.1.33).\\ | ||
| - | - Go to the [[basic-network|Network]] menu//. //In the //IP Address// field in the LAN section, assign | + | - Go to the [[basic-network|Network]] menu//. //In the //IP Address// field in the LAN section: |
| - | - Log on to the secondary router via 192.168.1.2. In the [[basic-network|Network]] menu//, //configure the settings of the interface that \\ matches | + | - Enter an IP address in the same subnet as the primary router, but outside the DHCP pool of your network. |
| + | - Uncheck the //Use DHCP// checkbox and click // | ||
| + | - Click Save. \\ \\ | ||
| + | - Log on to the secondary router via 192.168.1.2. In the [[basic-network|Network]] menu//, //configure the settings of the interface that \\ matches the primary router WiFi network you want to bridge (2.4GHz or 5GHz) as follows: \\ \\ | ||
| - Set Wireless Mode to: Wireless Ethernet Bridge | - Set Wireless Mode to: Wireless Ethernet Bridge | ||
| - Set Wireless Network Mode to: Auto | - Set Wireless Network Mode to: Auto | ||
wireless_ethernet_bridge.txt · Last modified: 2023/06/18 22:28 by hogwild
Page Tools
