Differences

This shows you the differences between two versions of the page.

--- advanced-pbr [2023/06/10 17:27] – [MultiWan Routing] -change title to "MultiWAN" hogwild
+++ advanced-pbr [2024/11/27 01:23] (current) – [Rules] hogwild
@@ Line 1: / Line 1: @@
-===== MultiWAN Routing =====
+====== MultiWAN Routing ======
 While somewhat similar to the Routing menu, the MultiWAN Routing menu allows you to direct outbound traffic in multiwan scenarios.
-This menu lets you define advanced parameters to make a connection bind to a specific WAN. Where outbound traffic is directed will implicitly affect the corresponding (inbound) return traffic. A packet going to WAN0 should return only via the same interface.
+Here, you can define advanced parameters to make a connection bind to a specific WAN interface. Where outbound traffic is directed will implicitly affect the corresponding (inbound) return traffic. A packet going to WAN0 should return only via the same interface.
@@ Line 10: / Line 10: @@
 {{:pasted:20220126-181958.png}}\\  \\
-**On**: When checked, this enables the routing rule on that line of the table.
+**On**: when checked, this enables the routing rule on that line of the table.
-**Protocol**:  This lets you choose the transport protocols that will be matched by the rule. There are hundreds of layer 4 protocols. This menu and setting refer to only the most common ones.
+ \\
+**Protocol**: lets you choose the transport protocols to be matched by the rule.
+Hundreds of L4 protocols exist. This setting refers to the most common ones.
   * All Protocols * (Default).
-  * TCP+UDP
+  * TCP + UDP
   * TCP
   * UDP
   * ICMP
-**Source Address**:  Filters in the defined source of traffic. All filters in all LAN devices. The IP setting allows you to define a specific IP address or set of addresses using a netmask syntax (e.g. 192.168.1.0/24), where MAC binds the rule to a defined MAC Address only.
+ \\
-  * All
+**Source Address**: filters in the defined source of traffic.
-  * IP
-  * MAC
-**Destination Address**:  Similar to the source IP, the destination address makes the rule more restrictive based on/or destination address. This can be defined as ALL (as in Internet), IP address or set of addresses, defined in a netmask format or even a destination domain.
+  * All - filters in all LAN devices.
+  * IP - lets you define a specific IP address or set of addresses. \\ using a netmask syntax (e.g. 192.168.1.0/24).
+  * MAC - binds the rule to a defined MAC Address only.
-  * All
+ \\
-  * IP
-  * Domain
-**Select WAN**:  (WANx) - Here, you choose the logical interface where the defined outbound traffic will be directed.
+**Destination Address**: Similar to //source address//, but makes a more restrictive rule, based on destination address.
-**Description**: In this field, you can enter any notes you wish to make management easier.\\
+  * All - all IP Addresses on the Internet.
+  * IP - one ore more IP Addresses (in netmask format).
+  * Domain - a destination domain.
-Rules defined will take precedence over any WAN's weight-related setting.
+ \\
+**Select WAN**: (WANx) - here, choose the logical interface where defined outbound traffic will be directed.
  \\
- \\ \\
+**Description**: in this field, enter any notes to help you make management easier.\\
+ \\
+Note that Rules defined will take precedence over any WAN's weight-related setting.
+ \\

FreshTomato Wiki

User Tools

Site Tools

Differences

Page Tools