This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
advanced-pbr [2022/01/26 18:33] – rs232 | advanced-pbr [2023/06/10 17:27] (current) – [MultiWan Routing] -change title to "MultiWAN" hogwild | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== MultiWan | + | ===== MultiWAN |
- | Similarly | + | While somewhat similar |
- | {{: | + | This menu lets you define advanced parameters to make a connection bind to a specific WAN. Where outbound traffic is directed will implicitly affect the corresponding (inbound) return traffic. A packet going to WAN0 should return only via the same interface. |
+ | |||
+ | |||
+ | ===== Rules ===== | ||
+ | |||
+ | {{: | ||
+ | |||
+ | **On**: When checked, this enables the routing rule on that line of the table. | ||
+ | |||
+ | **Protocol**: | ||
+ | |||
+ | * All Protocols * (Default). | ||
+ | * TCP+UDP | ||
+ | * TCP | ||
+ | * UDP | ||
+ | * ICMP | ||
+ | |||
+ | **Source Address**: | ||
+ | |||
+ | * All | ||
+ | * IP | ||
+ | * MAC | ||
+ | |||
+ | **Destination Address**: | ||
+ | |||
+ | * All | ||
+ | * IP | ||
+ | * Domain | ||
+ | |||
+ | **Select WAN**: | ||
+ | |||
+ | **Description**: | ||
+ | |||
+ | Rules defined will take precedence over any WAN's weight-related setting. | ||
+ | |||
+ | \\ | ||
+ | |||
+ | | ||
- | **On**: If enabled makes the rule active.\\ | ||
- | **Protocol**: | ||
- | **Source Address**: All/IP/MAC - Filters in the defined source of traffic. All stands for all LAN devices, IP allows you to define a specific IP or set of IPs in a netmask syntax (e.g. 192.168.1.0/ | ||
- | **Destination Address**: All/ | ||
- | **Selected WAN**: WANx - Is the logical interface where the defined traffic should be sent to in outbound.\\ | ||
- | **Description**: | ||
- | Please note the rule defined will take precedence over any WAN's weight related setting.\\ |