This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
enable_disable_ethernet_port [2020/09/29 14:11] – rs232 | enable_disable_ethernet_port [2023/05/24 01:38] (current) – hogwild | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | You can enable/ | + | ====== Enable/ |
- | To identify the port use the command | + | You can enable/ |
- | < | + | \\ |
- | robocfg show port | + | |
+ | To identify the port, use the command: | ||
+ | |||
+ | \\ | ||
+ | |||
+ | <code -> | ||
+ | robocfg show port | ||
</ | </ | ||
- | Once the physical port is identified, to disable (replace x with the port number): | + | |
- | < | + | \\ |
- | | + | |
+ | <code -> | ||
+ | robocfg port x state disabled | ||
</ | </ | ||
- | To enable instead: | + | \\ |
- | < | + | |
- | robocfg port x state enabled | + | |
+ | \\ | ||
+ | |||
+ | <code -> | ||
+ | robocfg port x state enabled | ||
</ | </ | ||
- | NOTE: you might be trying to fix an issue with an ethernet | + | \\ \\ You might be trying to resolve |
- | < | + | \\ |
+ | |||
+ | < | ||
robocfg port 2 media 10FD | robocfg port 2 media 10FD | ||
robocfg port 2 media auto | robocfg port 2 media auto | ||
- | |||
</ | </ | ||
+ | |||
+ | \\ | ||
+ | |||
+ | \\ | ||
+ | |||
+ | \\ | ||