FreshTomato Wiki

This is an old revision of the document!

---

You can enable/disable specific LAN ports via command line as follow.

To identify the port use the command

robocfg show port

Once the physical port is identified, to disable (replace x with the port number):

 robocfg port x state disabled

To enable instead:

robocfg port x state enabled

NOTE: you might be trying to fix an issue with an ethernet connected device. If the issue is the negotiated speed you can also try a dfferent approach like forcing 10MB Full Duplex before setting it back to Auto-negotiation again e.g.

robocfg port 2 media 10FD
robocfg port 2 media auto