Differences

This shows you the differences between two versions of the page.

--- enable_disable_ethernet_port [2023/04/23 21:08] – rs232
+++ enable_disable_ethernet_port [2023/05/24 01:38] (current) – hogwild
@@ Line 1: / Line 1: @@
 ====== Enable/disable Ethernet port(s) ======
- You can enable/disable specific LAN ports via command line as follow.
+You can enable/disable specific LAN ports via command line as follows:
+ \\
 To identify the port, use the command:
+ \\
 <code ->
@@ Line 9: / Line 13: @@
 </code>
- \\  Once the physical port is identified, to disable it (replace x with relevant port number on your router):
+ \\  \\ \\  Once the physical port is identified, to disable it (replace x with relevant port number on your router):
+ \\
 <code ->
@@ Line 15: / Line 21: @@
 </code>
- \\  To enable it:
+ \\
+ \\  \\ To enable it:
+ \\
 <code ->
@@ Line 21: / Line 31: @@
 </code>
- \\  NOTE: you might be trying to fix an issue with an Ethernet connected device. If the issue is the negotiated speed you can also try a dfferent approach, like forcing 10MB/s Full Duplex before setting it back to Auto-negotiation again. For example:
+ \\ \\ You might be trying to resolve an issue with an Ethernet-connected device. If the negotiated speed is causing the problem, you can test forcing 10MB/s Full Duplex connections before setting it back to Auto-negotiation. For example:
+ \\
 <code ->
@@ Line 27: / Line 39: @@
 robocfg port 2 media auto
 </code>
+ \\
+ \\
+ \\

FreshTomato Wiki